RBT Measurement Quiz 2

Challenge your knowledge with 12 new questions on frequency, duration, latency, inter-response time, and interval recording to prepare for the RBT exam.

Question 1 of 12

A client claps their hands 12 times during a 3-hour session. What is the frequency of the clapping behavior?

a) 12 times b) 4 times per hour c) 36 times d) 6 times

Question 2 of 12

You measure the time a client spends reading a book during a 1-hour session, and it totals 15 minutes. What is the duration percentage?

a) 15% b) 25% c) 30% d) 20%

Question 3 of 12

A client takes 20 seconds to start following an instruction to stack blocks. This is an example of measuring:

a) Duration b) Latency c) Frequency d) Inter-response time

Question 4 of 12

You are using momentary time sampling with 15-second intervals. This method is most appropriate for:

a) High-frequency behaviors b) Behaviors with short durations c) Continuous or long-duration behaviors d) Discrete behaviors with clear start and end

Question 5 of 12

A client engages in a behavior 4 times in 20 minutes. What is the rate of this behavior?

a) 0.2 times per minute b) 0.5 times per minute c) 4 times per minute d) 2 times per minute

Question 6 of 12

The time between consecutive instances of a client tapping their foot is 1 minute and 1.5 minutes. What is the average inter-response time (IRT)?

a) 1 minute b) 1.25 minutes c) 1.5 minutes d) 2 minutes

Question 7 of 12

Which recording method requires the behavior to occur throughout the entire interval to be marked?

a) Partial interval recording b) Whole interval recording c) Momentary time sampling d) Frequency recording

Question 8 of 12

You count the number of completed puzzles left by a client after a session. This is an example of:

a) Duration recording b) Permanent product recording c) Latency recording d) Inter-response time recording

Question 9 of 12

A client responds to an instruction after 10 seconds, and the behavior lasts for 5 minutes. What is the latency?

a) 5 minutes b) 10 seconds c) 5 minutes 10 seconds d) 15 seconds

Question 10 of 12

Partial interval recording is likely to overestimate:

a) Low-frequency behaviors b) High-frequency behaviors c) Long-duration behaviors d) Behaviors with clear endpoints

Question 11 of 12

Recording every instance of a behavior as it occurs is known as:

a) Discontinuous measurement b) Continuous measurement c) Partial interval recording d) Momentary time sampling

Question 12 of 12

A client completes 10 tasks in 2 hours. What is the rate of task completion?

a) 5 tasks per hour b) 10 tasks per hour c) 2 tasks per hour d) 0.083 tasks per minute

RBT Exam Practice Tests